Flexi-Shed Glass

HDPE Film Backed Glass Based Shed Felt
HDPE Film Backed
Suitable for Non Habitable Buildings
Available in 10m & 20m Rolls

PRODUCT USE
Primarily intended for use as an economical
weatherproofing membrane for sheds, non-habitable
garden buildings and animal Shelters. Life expectancy
of the product varies greatly due to exposure to
weather elements and also quality of installation.

COMPOSITION AND MANUFACTURE
The base carrier consists of a glass fibre Matting
which is coated both sides in modified bitumen. The
coated material is finished with a fine mineral
granule on one side to aid UV protection and a thin
HDPE film lower surface on the reverse.
The membrane is cut to roll length,
wrapped and labelled according to specification and
customer requirement.

INSTALLATION
Flexi-Shed Glass can be used as a Single layer,
but for best performance install over a suitable
underlay which should be nailed onto the substrate.
Flexi-Shed should then be installed using clout
Nails and felt adhesive to seal the laps (75mm min).
Start from the eaves (lengthwise), work upwards and
finish with overlaying the ridge.When installed as a
single layer the minimum Pitch of the roof should be
greater than 20 degrees. Membranes coated with
oxidised bitumen remain flexible above 5°c. During
colder periods care must be taken when handling
and installing as to prevent cracking of the bitumen
and damaging the membrane.
It is not recommended to use below 5°c.

STORAGE & HANDLING
Do not drag rolls across rough surfaces, they should
be lifted. They should be stood on their end on a dry
surface. If using pallets do not stack more than
2 high. Avoid mechanical damage and wet storage
conditions. During colder periods it is recommended
that rolls are stored at a temperature above 10°c for
24 hours prior to use, and not unrolled, folded or used
in temperatures below 5°c.