ProBor 10 is a liquid wood-preservative based on boron, a naturally occurring mineral with a long history of use. It is supplied ready-for-use in 5 litre and 25 litre jerry cans.
ProBor 10 has an active ingredient content of 10% and can be applied by brush or spray. It is suitable for the treatment of woodworm in all dry timbers and as part of a dry rot and wet rot control strategy in smaller dimension timbers (up to 19 mm 38 mm). For the treatment of dry rot and wet rot in larger dimension timbers, ProBor 20 or ProBor 50 should be used.
Dual Purpose Approved for use as a woodworm treatment and as a dry / wet rot treatment.
Superior Penetration Penetrates more deeply into Timber than conventional wood preservatives.
Low Odour Formulation Fewer complaints.
Full details about ProBor 10 can be found in the ProBor 10 datasheet which can be downloaded from this page. A 19-page guide, Dry Rot & its Control can also be downloaded.
Please note that these product properties are not a replacement for the manufacturer's literature and it is always recommended that Safeguard Europe is consulted before specifying.
|
|
||
| Storage (?) | Store above 10 C in dry conditions in original container. If the temperature falls below 10 C there is a risk that crystals may form in the product. If this occurs - the product should not be used. Store in a safe place - keep out of reach of children. Ke | |
|
|
||
| Coverage Rate (?) | 4 m2/l | |
|
|
||
| Uniclass (?) | Pr_35_31_68 Protective coatings | |