Burners

    40 Products

    ETC6000 Oxygen Trim Option

    Energy Technology & Control Ltd
    The ETC6080 oxygen trim interface and software that allows an oxygen probe to be added to the ETC6000 Integrated Combustion Controller or the ETC6100 Fuel:Air Ratio. By monitoring the oxygen level in the exhaust gas flue fine adjustments can be applied to the...

    2 specifiers have shown an interest in this product the last month.

    GB 3160

    Nu-Way Ltd
    Gas boosters are used to increase the supply pressure of gas when a higher pressure is required to supply a gas burner. The range is suitable for use on natural gas and town gas....

    ETC6100 Fuel Air Ratio Controller

    Energy Technology & Control Ltd
    ETC6100 – This Fuel Air Ratio Controller (FARC) suitable for use with a variety of burner control boxes to enhance combustion control from single point to multi element control with options for fan speed control via Variable Frequency Drive and oxygen trim w...

    2 specifiers have shown an interest in this product the last month.

    PG 490

    Nu-Way Ltd
    The PG Series burner can operate on gas (NG, LPG, Towns Gas and Biogas) and is available in standard outputs from 3.3MW to 18MW. The PG Series burner is commonly used on large industrial steam and hot water boilers....

    1 specifiers have shown an interest in this product the last month.

    Country 16B Multifuel

    Charnwood
    OUTPUT TO ROOM:   6.4kW (range 2-8kW)            OUTPUT TO WATER: 13.2kW HEATING CAPACITY: DHW and approx. 10 radiators MATERIAL: Plate steel, cast iron, fire brick, ceramic glass FEATURES: * Cleanburn airwash technology * Converting grate for...

    2 specifiers have shown an interest in this product the last month.

    COMPRESSED GAS MANUAL MANIFOLDS

    C S Milne Engineering Ltd
    The manual changeover manifolds are manufactured to operate in conjunction with cylinders filled up to 300 bar and are ideally suited to the requirements of industrial applications where cylinder gases are used. These manifolds are designed to accommodate 2 ...

    8 specifiers have shown an interest in this product the last month.

    ETC6075Touch-screen Display Panel.

    Energy Technology & Control Ltd
    The home-screen is a graphical representation of the boiler, burner and fuel delivery system. In addition, the current operating status, the values of any installed pressure or temperature sensors and any alarm conditions are also displayed. During burner sta...

    2 specifiers have shown an interest in this product the last month.

    ETC6003 Combustion Controller

    Energy Technology & Control Ltd
    ETC6003 – This integrated controller is designed for modulating, dual Gas burners, in single or mixed profiles. There are options of fan speed control via variable frequency drive (VFD), and oxygen trim, which further improve burner efficiency. The ETC6003...

    1 specifiers have shown an interest in this product the last month.

    ETC6002 Combustion Controllers 

    Energy Technology & Control Ltd
    ETC6002 – This integrated combustion controller is configured to manage dual fuel burners that fully modulate on Gas and stage fire for Oil (2, 3, 4 or 5 stage) referenced to a modulating air damper. There are options of fan speed control via variable frequ...

    2 specifiers have shown an interest in this product the last month.

    ETC6008 Integrated Combustion Controller

    Energy Technology & Control Ltd
    ETC6008 – Similar to ETC6000 but has a blending function when firing mixed fuel profiles to bias the use of one fuel rather that the other depending upon fuel availability. The blending function is controlled by a signal from external systems. Oxygen trim is...

    ETC6009 Integrated Combustion Controller

    Energy Technology & Control Ltd
    ETC6009 – Similar to ETC6003 but has a blending function when firing mixed gas profiles to bias the use of one gas rather that the other depending upon availability. The blending function is controller by a signal from external systems and, as with ETC6008, ...

    ETC2800 Flue Gas Oxygen Analyser

    Energy Technology & Control Ltd
    ETC2800 – This microprocessor based Flue Gas Oxygen Analyser utilising ETC’s industry leading zirconia oxide ‘in-situ’ oxygen / temperature probe. The ETC2800 Flue Gas Oxygen Analyser offers numerous features Measures flue gas temperature and oxygen c...

    3 specifiers have shown an interest in this product the last month.

    ETC6000 Actuator & Servo Motors

    Energy Technology & Control Ltd
    ETC offers a wide choice of dedicated servo motors ranging from 4-40Nm in size for use with the ETC6000. These servo motors accurately position air dampers and fuel valves to a resolution of 0.1º over a 90º stroke, allowing fuel:air ratio profiles to be reli...

    Boiler & Burner Sensors

    Energy Technology & Control Ltd
    ETC offers a range of dedicated self-checking pressure and temperature sensors for use as part of an ETC6000 system. The ETC1021 Gas Pressure Sensor is installed between the two gas isolating valves on the gas train. Once installed the sensor can be used as p...

    3 specifiers have shown an interest in this product the last month.

    X Series Domestic/Light Commercial Oil Burners

    EOGB Energy Products Ltd
    14 – 100kW Single Stage. Model range: X400 – X500 – X600 – See output graphs below. Suitable for use with Kerosene, Gas Oil and FAME based Bio Fuel blends up to B10 as standard. B30 spec can be supplied under special order. Designed and manufactured ...

    ETC6000 Combustion Controller

    Energy Technology & Control Ltd
    ETC6000 –This controller is designed to manage modulating, dual fuel (Gas plus Oil) burners as single fuel profiles or mixed profiles. There are options of fan speed control via variable frequency drive (VFD), and oxygen trim, which further improve burner ef...

    Modulating 415 – 10,500 kW

    EOGB Energy Products Ltd
    Two-stage progressive output operation. • Ability to operate with output modulation by means of automatic RWF40 regulator mounted on the control panel (to be ordered separately with the modulation kit). • Ability to obtain optimal combustion values by regu...

    GU 200

    Nu-Way Ltd
    The GU Series oil burner is designed to use a variety of oils including waste oil as a fuel. The burner features air atomisation and an integral oil pre-heater tank to assist the oil atomisation to achieve efficient combustion, and therefore requires a compre...

    1 specifiers have shown an interest in this product the last month.

    ETC6066Text Based HMI

    Energy Technology & Control Ltd
    This text based HMI’s is the entry level display module providing information from the ETC6000 series controllers through a variety of menus. This display has a membrane keypad for the equipment operator to be able to select items for display and to change t...

    Baltur Commercial Oil Burner Single stage 17 – 390 kW

    EOGB Energy Products Ltd
    Baltur oil burners available from 17kW to 10,500kW. Model range includes: BTL, Spark, TBL and BT in Light and Heavy oil variants. Two stage Rinox and LX versions offer Low NOx down to Class III. Suitable for use with Gas oil, plus FAME based Bio Fuel blends up...

    1 specifiers have shown an interest in this product the last month.

    Heavy oil 55 – 10,500 kW

    EOGB Energy Products Ltd
    • Single stage operation (on/off). • Ability to obtain optimal combustion values by regulating combustion air and blast-pipe. • Maintenance facilitated by the fact that the atomisation unit can be removed without having to remove the burner from the boil...

    Burners Building Products

    Burners are devices that burn gasses or liquids in a controlled manner, so that includes multiple fuel burners, which tend to be used in domestic environments to provide heat and light, and gas pressure booster sets, which are typically used in industrial settings.
    Through SpecifiedBy, you can search and compare an extensive range of Burners from leading UK manufacturers such as Charnwood and C S Milne Engineering Ltd.
    Source the best Air Burners for your project, including the Charnwood 16B Multifuel Burner, which is ideal for domestic applications, offering the same heating capacity of approximately 10 radiators and is also suitable for use with under floor heating, and the C S Milne Engineering Ltd Compressed Gas Manual Manifolds – which has been designed specifically for use in industrial applications where cylinder gases are used.