Econoboard Coated Insulation Boards

Econoboard Coated underfloor heating insulation boards are manufactured using a high-density extruded polystyrene core with a polymer modified, glass fibre reinforced cement coating on both sides, which adds rigidity and strength. Using Econoboard Coated and the range of accessories accessories quickly creates an ideal, stable substrate for thin/thick bed tile adhesive and underfloor heating.

When fixing tiles onto a timber floor it will generally need strengthening. This can be done using a minimum thickness of 6mm Econoboard Coated, which must be fixed with a flexible cement-based tile adhesive. Only 6mm Econoboard Coated must be fixed with adhesive, thicker boards can be fixed with adhesive or screws and washers. Ensure that all floorboards are screwed down thoroughly at 300mm centres before fixing Econoboard Coated. Ideally lay the Econoboard Coated across the floorboards at 90 for maximum stability.

Before fixing Econoboard Coated to any floor make sure it is free from dust or any loose materials. If your adhesive manufacturer recommends it, treat the floor with a suitable primer to ensure good adhesion. Solid concrete floors transfer the cold and damp from below so Econoboard Coated should be used before tiling for its excellent thermal properties. It is particularly beneficial when installing underfloor heating onto a concrete substrate.

When underfloor heating is being installed, Econoboard Coated is recommended for its superior thermal properties. The thermal properties of Econoboard Coated minimise the amount of heat lost through the substrate making your underfloor heating system up to 50% more efficient and cheaper to run. Thicker boards will give you a better level of insulation and Econoboard Coated is available from 6mm to 50mm, to suit any project.