Stylite Partial Fill Cavity Insulation
by Styrene Packaging & Insulation
Stylite Partial Fill Cavity Wall Insulation Boards are available in both standard white EPS and enhanced grey PlusTherm EPS. Available with either tongue and groove edges or straight plain edges both provide a system that eliminates the passage of moisture from the outer skin to the inner skin of a building and insulates the building. Boards are supplied at 1200 x 450mm to allow easy installation with standard cavity wall tie spacing. Always design the cavity width with a minimum residual (air) cavity of 50mm as per NHBC guidelines.
Tongue and groove or plain edges
Prevents passage of moisture across the cavity
Easy installation with dimensions to fit with standard cavity wall tie spacing
Allow for a minimum residual cavity of 50mm
Thermal conductivity from 0.030 W/mK
Reduces cold bridging.
Lightweight
Quick and easy installation
Used in commercial and residential projects
Minimal water permeability
100% recyclable
No HFC s, CFC s or HCFC s
BRE green guide rating: A+
CE marked
Specification Details for Stylite Partial Fill Cavity Insulation (Insulation Boards)
Please note that these product properties are not a replacement for the manufacturer's literature and it is always recommended that Styrene Packaging & Insulation is consulted before specifying.
Technical
|
||
| Bending Strength (?) | 0.15 MPA | 100.00% |
| Compressive Stress at 10% Deformation (?) | 100 Kpa | 25.93% |
| Thermal Conductivity (?) | 0.036 W/mK | 12.21% |
Other
|
||
| Uniclass (?) | Pr_25_71_52 Mineral-based boards and sheets | |
File Downloads for Stylite Partial Fill Cavity Insulation
Contact
Contact
Contact
