Cable Grout
by Parex
A specially formulated Portland Cement shrinkage-compensated powder mix designed for the grouting of cables in post-tensioned concrete for EN 446(2007) and CARES Appendix PT10 procedures. The material readily mixes with water to produce a particularly fluid flowing grout which will penetrate and fill fine voids within and around the cables then harden without shrinking to give a high strength product. Uses include grouting of cable ducts, voids and fine fissures, support of cable anchor plates and ground anchors. Also to provide bearing or contact between structural elements, for grouting behind shafts and tunnel linings, and for underpinning, loose floor and road slabs.
Specification Details for Cable Grout (Miscellaneous)
Please note that these product properties are not a replacement for the manufacturer's literature and it is always recommended that Parex is consulted before specifying.
Certifications & Ratings
|
||
| Standards (?) | EN 196-1 , EN 196-3 , EN 445 , EN 446 , EN 447 , ISO 14001 , ISO 9001 , OHSAS 18001 | |
Materials & Finishes
|
||
| Material (?) | Portland cement based | |
Commercial
|
||
| Typical Use (?) | Grouting of cable ducts , Support of cable anchor plates | |
Technical
|
||
| Compressive Strength (?) | 65 N/mm2 | |
Looking for specific information on the sustainability credentials of this product?
File Downloads for Cable Grout
Similar Miscellaneous Products
Contact
Contact
Contact
