DELTA-MS20

DELTA -MS20 is a compression-resistant, durable dimpled sheet made from special high density polyethylene. This is a heavy gauge version of DELTA -MS with deep 20 mm studs. This is used where extra drainage capacity is required, for example on deeper structures, or where a larger flow rate is required. DELTA -MS20 can also be used as a cavity former for many types of new construction.

DELTA -MS20 is used as damp-proofing on Walls, floors and vaulted ceilings, above and below ground, in new construction or in existing buildings over a contaminated or damp background. It can support a dry lining, screed or flooring, in the following situations:

On damp walls and floors in underground situations subject to high groundwater levels, and perennial moisture
On vaulted ceilings of archways or cellars subject to water ingress
In conjunction with a remedial dpc system where the walls and floors have a high salt content, and/or it is necessary to complete the installation immediately without allowing a period for initial drying
Over walls and floors which have a friable or painted surface, are contaminated (eg with oil or mould), or have a high salt content
As a waterproofing membrane in areas subject to vibration.

Depending on the application required and the site conditions, the membrane may be used as:

An underfloor damp-proof / membrane
A dry lining for walls, ventilated into the room via aeration slots at the top and bottom of the wall or via passive air vents, where access through an external wall is available.
A sealed system covering wall, floor and ceiling with provision made for disposing of water build-up behind the membrane via a sump and pump.