MaxAtec 140 Single Seal Floor & Wall Expansion Joint
by Vexcolt
The MaxAtec 140-A01/A02/A07/A09 is an aluminum expansion joint with a TPE rubber seal. This joint is centre supported and has a ribbed surface for improved slip resistance.
This joint is suitable for floors (A01/A02) and walls (A07/A09) and provides good movement capacities suitable for pedestrian traffic.
This joint follows the Disability Discrimination Act (DDA) compliances across the entire movement cycle.
Specification Details for MaxAtec 140 Single Seal Floor & Wall Expansion Joint (Expansion Joints)
Please note that these product properties are not a replacement for the manufacturer's literature and it is always recommended that Vexcolt is consulted before specifying.
Size & Weight
Materials & Finishes
Physical Properties
|
||
| Installation (?) | A01 - Floor to Floor , A02 - Floor to Wall | |
| Max Load kN (?) | 30 kN | 11.54% |
| Movement Type (?) | Horizontal , Lateral , Longitudinal , Vertical | |
Commercial
|
||
| Typical Building Sector (?) | Commercial , Domestic , Education , Hospitality | |
| Typical Building Type (?) | Airports , Exhibition halls , Hospitals , Hotels , Metro Stations , Museums , Offices , Schools , Shopping Centres , Stadiums , Supermarkets | |
Other
|
||
| Location Suitability (?) | External , Internal | |
| Uniclass (?) | Pr_35_90_27 Expansion joints | |
Looking for specific information on the sustainability credentials of this product?
File Downloads for MaxAtec 140 Single Seal Floor & Wall Expansion Joint
Similar Expansion Joints Products
Contact
Contact
Contact
