Aquarius XLINE Operating Louvre Systems

All Aquarius™ XLINE AQ50, AQ75 and AQ100 louvre systems can be supplied as 'moveable' operating units. Operation can be via hand lever control where access is available to the back of the louvre panel or via linear driven actuator motors fitted to drive open and closed the louvre blades when remotely positioned within the building.


Hand 'Lever' Operated Louvres

A simple, friction stay, lever handle allows the building occupants to open/close the louvres to their own particular requirements. The louvres will stay where positioned and will require manual closing aduring inclement weather conditions or at the end day when the building closes and is not occupied.


Remote Motorised Louvres

Motorised Louvre panels are provided when access to the rear is not easily available and extended control via switch boxes or the building BMS system is preferred.

Operating louvre panels can be formed from the XLINE-AQ50, AQ75 and AQ100 louvre system with a maximum panel width of 1200mm and up to 3m2 cover area subject to Solinear design review. The operating louvre blades overlap and have front edge seals and jamb seals to minimise air leakage.

A direct drive link bar couples all blades to allow open/close rotational operation by hand or via an electric linear actuator. For a step incremental positioning operation of the louvres then a 24V voltage regulation actuator is available otherwise a simple 240V actuator will provide fully open or fully closed cycle to the louvre panel. On loss of power the motor will remain where positioned at time of this power loss. A 'failsafe' motor unit is also available which will drive the louvre to a pre-set position on loss or failure of power to the building or louvres.