McAlpine 50 Millimetre Water Seal Gully with Horizontal Outlet for Tiled or Stone Floors

50 Millimetre Water Seal Trapped Gully, Tile/Grating with removable Grid, 2 inch Horizontal Outlet and 2 inch x 1.50 Inch Socket Reducer
Available with Polished Stainless Steel or White ABS tile or Circular Polished Stainless Steel grating.
50 Millimetre Water Seal.
2 inch BS EN 1329-1:2000 Solvent Weld Horizontal Outlet.
Supplied with 2 inch x 1.50 inch socket reducerTiled or Stone floor gully suitable for concrete and suspended Timber floors.
Manufactured in ABS to the highest quality.
Overall height 100 Millimetre.
Flow rates of 48 litres per minute exceed the minimum requirement of EN 1253-2:2003 and are variable dependent on the cover plate used.
Ideal for Showers in domestic wet rooms, disabled and student accommodation, Bathroom Pods, retirement and care homes, Hotels, hospitals and sport and leisure.

Installation Guidelines - Tiled Floors
The minimum dimension between the gully flange and top surface of the gully tile or grating - which needs to be flush with the flooring - is 13 Millimetre. This size cannot be reduced but if required, the gully tile or grating can be raised. To do this, remove the centre from the dust cap/extension ring and solvent weld the extension ring to the upstand of the clamp ring. If additional height is necessary, an appropriate length of 110 Millimetre pipe can be solvent welded between the extension ring and the underside of the gully tile or grating.Ensure the gully body is fully supported. Do not rely solely on the gully flange for support.A good quality waterproofing membrane should be employed to prevent water penetration to the floor structure. Ensure that the underside of the membrane is sealed to the gully flange and secured by the clamp ring to the gully body.The clamp ring has weep holes to allow any moisture to discharge into the gully.