Find, compare and price building products without wasting time on visiting, registering, & navigating multiple manufacturer websites, downloading countless technical documents for comparison, or waiting days for quotes.
Built to get you results quickly.
Products & information updated daily.
All the information you need in one place.
The largest product database in the UK.
The design and fitout of buildings should focus on people's safety. Securing exit routes is especially important. Special solutions for exit doors must enable fast escape in an emergency. This means that a user must be able to open emergency exits by hand with minimum effort and without prior knowledge of how to operate the panic exit device. HEWI panic bars can be operated intuitively with minimum effort and therefore fulfil the EN 1125 requirements for panic door devices. for equipping exit doors - approval to EN 1125 only in combination with tested locks - with CE marking. Approved for fire and smoke doors, listing in the national technical approval test certificate of the respective door manufacturer in conjunction with DIN 18273, DIN 4102, DIN 1634, for single leaf or double doorsets in escape routes (inactive or inactive and active leaf)
Handle made of stainless steel, diameter 25 mm with tubular handle made of polyamide, diameter 30 mm. Handle tube positioned as one-sided handle, therefore clear visualisation of the optimum pressure point on the lock side, conforms to the requirements of DIN 18040. The stainless steel tubes are connected by a square bar - telescopic. Low projection depending on the operating angle of the lock follower, but at least in accordance with DIN 1125, grade 2: 761 mm) at customer request, specify exact measurement. For use on timber and steel doors and metal frame doors, backset from 35 mm (depending on profile) as single or double doorset. Concealed, tamper-resistant screw fixing with threaded screws M5. Gear unit and the thrust bearing with cover, width of the rosette 27.7 mm, width of the transmission unit 45 mm, no jamming due to splayed surfaces of the gear unit cover on the lock side and positioning of the push-bar on the inside of the gear unit. Surface satin finished
Attention! In order to meet the requirements of EN 1125, the panic bar can only be used with certified locks of the lock manufacturers: Assa Abloy, BKS, BMH, Fuhr, GEZE, Grundmann, KFV, MSL, DOM or Wilka - further details on the certified locks see under www.hewi.de Available versions of handle tube: in HEWI colour 98 (signal white), 99 (pure white), 92 (anthracite grey), 90 (jet black), 73 (meadow green), 33 (ruby red) and stainless steel satin finished (A).
|Certifications & Ratings|
|Standards (?)||DIN 18040, DIN 1634, DIN 4102, DIN 18273, EN 1125|
|Materials & Finishes|
|Colour(s) (?)||White, Red, Green, Black, Grey|
© SpecifiedBy 2018. All rights reserved.