CellPave™ AP - Anchored Grass Reinforcement Paver

by Groundtrax

CellPave AP from Groundtrax is a ‘no-dig’ anchored ground reinforcement paving tile.

This is laid onto and vibrated into existing established grassed areas to create a strong and stable surface.

CellPave AP has a unique design which suppresses resurgence of mud from below. The openings ensure effective drainage. Ground anchors on the underside of the tiles ensure the best possible fixing, even in poor ground or under heavy loads. Over time, the integration with the ground also increases as the existing grass root intertwines with the tile structure.

Features and Benefits:

• Grass grows back through the tile, preserving the character of the environment

• Tiles allow water to pass through them

• Natural drainage maintained

• No splintering or risk of injury

• No special tooling or skills required for installation

• Easy to self-install

• Can be removed later, if required

• Low cost when compared to alternative options

• Normally requires no excavation, unlike most other grass reinforcement products

• Robust clip system

• Simple 'snap-in' markers available

• Resistant to most aggressive substances

• Planning permission may not be required

Specification Details for CellPave™ AP - Anchored Grass Reinforcement Paver (Surfacing)

Please note that these product properties are not a replacement for the manufacturer's literature and it is always recommended that Groundtrax is consulted before specifying.

Looking for specific information on the sustainability credentials of this product?

File Downloads for CellPave™ AP - Anchored Grass Reinforcement Paver

Clear selection

One-Click Quote

  • Automotive Visitor Centre, West London – 13,440m²
  • Historic House, Leeds – 9,600m²
  • Visitor Attraction, Leeds – 9,000m²
  • Airfield, Nottinghamshire – 8,400m²
  • School, Warwickshire – 7,600m²
  • Farm Shop, Wrexham – 5,280m²
  • National Trust, Devon – 5,280m²
  • Airfield, Aberdeenshire – 4,480m²
  • Historic House, Cheshire – 4,000m²
  • National Trust, Cheshire – 3,000m²
  • Hospital, Kent – 2,240m²












Also known as grass grids, gravel grids, grass and gravel stabilisation, parking grids and permeable paving, this type of product is a cost effective and environmentally responsible alternative to traditional surfaces such as tarmac and concrete.


CellPave™ AP plastic pavers have been designed to be installed with both gravel and grassed infills. They are particularly suitable for incorporation into a SuDS compliant system and may even negate the need for water attenuation when installed on a suitable porous substrate.


CellPave AP can be installed for the following applications:

  • Green parking areas
  • Emergency vehicle access
  • Temporary and permanent roadways
  • Road protection
  • Embankments
  • Driveways
  • Tree beds
  • Golf walkways
  • Caravan parking
  • Hard standing storage areas

CellPave AP is installed quickly and easily and it provides a cost-effective way of reinforcing existing grassed areas. It is used extensively for car parking and to reinforce grassed aircraft runways and taxiways. The grids are a much stronger alternative to roll out meshes that are pinned into place as the grids themselves are vibrated into the ground with a vibratory roller.

PLEASE NOTE

This product should only be considered for installation into well-established grassed areas and the ground should be free draining.

During prolonged wet weather, some muddy areas may still develop, and the success of the product is very much dependent upon the bearing capacity of the existing ground.