Hiline Custom - Bespoke Pre-insulated Pipes

Manufactured in accordance with BS EN 253, this rigid, bonded pre-insulated  pipe system is suitable for a variety of  applications - temperatures up to 95°C continuous. Available in dimensions ranging from 20mm to 250mm OD and supplied in 6 and 12 metres lengths.

The list of applications that are suitable for  Hiline Custom is vast, but typically, it is used above and below-ground, on domestic, commercial and industrial sites for conveying:

Pre-insulated pipes and fittings for thermal utilities are manufactured within an ISO 9001 accredited environment in accordance with EN 253, EN 448, EN 488, EN 489, EN 13941

Hiline Custom is available with a choice of a wide range of  pipes, including (but not limited to): PP-R, PP-RCT, PP-B, PP-H, ABS, PVC, PVDF, PE100, FRP and service pipes of other thermoplastic materials. It is commonly supplied with CPV Chemflo polypropylene manufactured from beige grey (RAL 7032) polypropylene block copolymer (PP-B) to dimensions and tolerances as specified in ISO 15494:2003. The quality standards and testing regime for the pipe are to DIN 8078 (Type 2 (PP-B)):1994 with the pipe having high impact resistance at sub-zero temperatures.

A key component in the efficiency of the Hiline pipe systems is our choice of CFC-free polyurethane foam to provide excellent levels of insulation – in accordance with the demands of the EN 253 standard. Using cyclopentane as the blowing agent, we achieve very-low lambda levels – which result in much-reduced energy losses to the media being conveyed by the service pipe. The effects of using a more efficient insulation don’t appear to be much at face value, but factor in a 30-year life-cycle cost of operating the system and the savings – both financial and environmental – mount up significantly. When looking at the life-cycle-costs of a district heating pipe network, the initial capital investment is typically around ten percent – with the biggest cost being the on-going operation.

Casing pipe is manufactured in accordance with standard EN 253 from high density polyethylene (HDPE). Barrier casings are also available for applications in contaminated ground.



HDPE casing is also available with additional UV stabiliser offering greater protection against direct sunlight for above ground installations and with a barrier casing for use in contaminated ground.

In the case of Faser PP-R pre-insulated pipes to be installed in above and below ground thermal utilities,  the following techniques for thermoplastic welding can be used:

The sealing of HDPE casing pipes in the field can be carried out using the following techniques:

Hiline systems are manufactured in modern, EN ISO 9001-approved production facilities, using quality-assured materials that comply with all relevant design standards and tolerances for district heating and cooling – such as EN 253, along with any that are pertinent to special applications.