98 Products • Ground & Substructure

    Void Fill (Civil Engineering) EPS Road and Rail embankments

    S and B EPS Ltd
    With its high strength-to-weight ratio and ability to withstand mechanical loads, S and B fill can assist in reducing the pressure on soils when taking into account the high unacceptable loadings that can be present, whilst offering a proven economical alterna...

    23 specifiers have shown an interest in this product the last month.

    See more like this

    Basement Waterproofing Products

    Newton Waterproofing Systems
    Basement Waterproofing With Newton System 500 Cavity Drain System Newton System 500 is an internally applied basement waterproofing systems based upon our extensive range of cavity drain membranes, drainage conduits and sophisticated pumping and control sys...

    24 specifiers have shown an interest in this product the last month.

    See more like this

    TT55-TTME

    Triton Systems
    Triton Tanking Mix Elastifier (TTME) is a plasticiser-free dispersion which is designed to be mixed with TT55 to produce a flexible waterproofing coating suitable for either vertical or horizontal surfaces. It is ideal for areas which are liable to cracking or...

    8 specifiers have shown an interest in this product the last month.

    See more like this

    DualProof - Pre-applied External Waterproofing Membrane

    Delta Membrane Systems
    Type A external (positive side) waterproofing DualProof is a fully and permanently bonded, self-adhesive, composite sheet which does not only waterproof but protects against gas and chemicals. It consists of a sealed two layer highly flexible PVC membrane lami...

    10 specifiers have shown an interest in this product the last month.

    See more like this

    Fillmaster

    Jablite
    Overview Jablite Fillmaster is often specified to replace traditional fill materials in civil engineering projects. Using traditional fill materials can cause unacceptable vertical or horizontal stresses in weak underlying soils or against structures. These s...

    18 specifiers have shown an interest in this product the last month.

    See more like this

    Drill-Terge

    CETCO
    DRILL-TERGE™ is liquid solution of non-ionic surfactants formulated to increase detergency and wetting properties of drilling fluids. Designed to work in fresh or saltwater to reduce torque and drag....

    3 specifiers have shown an interest in this product the last month.

    See more like this

    Secura Grand

    Tobermore
    Tobermore’s Secura range of retaining walling products provide architects, engineers, contractors and house builders with a cost-effective solution for all types and sizes of retaining wall projects. Secura Grand is generally used for larger or higher reta...

    31 specifiers have shown an interest in this product the last month.

    See more like this

    DELTA-MS500

    Delta Membrane Systems
    DELTA®-MS500 is a cavity drain membrane used as waterproofing / damp proofing on walls, floors and vaulted ceilings, above and below ground, in new construction or in existing buildings over a contaminated or damp background. Cost effective, simple to inst...

    7 specifiers have shown an interest in this product the last month.

    See more like this

    Retaining Wall – Shuttabloc™

    Poundfield Products
    Poundfields unique Shuttabloc™ concrete retaining wall system has been designed to provide a faster, more economical alternative to casting in-situ. Whilst traditional precast concrete units are suitable for retaining bulk materials in many circumstances, s...

    6 specifiers have shown an interest in this product the last month.

    See more like this

    Sacrificial Guide Wall Formers

    Cordek
    Sacrificial Guide Wall Formers are used to accurately form an in-situ concrete guide wall which is critical in the positioning and alignment of piles in a contiguous or secant piled wall. From a customerÕs pile layout plan Cordek will produce a drawing detail...

    7 specifiers have shown an interest in this product the last month.

    See more like this

    DELTA-PT

    Delta Membrane Systems
    DELTA®-PT is a special HDPE waterproofing membrane which is extruded into a series of studs. The purpose of the studs is to create a continuous air gap behind the waterproof membrane. On the face of the membrane a welded mesh allows plasters and renders to bo...

    5 specifiers have shown an interest in this product the last month.

    See more like this

    Basement Waterproofing Membranes

    Delta Membrane Systems
    Our range of membranes are manufactured with air gap technology, they consist of a high-density polyethylene (HDPE) sheet, molded into a series of raised studs, or dimples. When the membrane is applied to the substrate the studs create an air gap cavity. This ...

    6 specifiers have shown an interest in this product the last month.

    See more like this

    Super Gel-X

    CETCO
    SUPER GEL-X® is a 200 bbl yield bentonite drilling fluid for maximum viscosity. Controls filtration rate for borehole stabilization and prevention of fluid loss....

    2 specifiers have shown an interest in this product the last month.

    See more like this

    DELTA-FM slim-line damp proof membrane

    Delta Membrane Systems
    DELTA®-FM is specifically designed for floor applications to combat dampness and contamination. The special low stud profile (3mm) minimises changes in floor levels but still provides an air gap to achieve damp pressure equalisation....

    7 specifiers have shown an interest in this product the last month.

    See more like this

    Super Pac

    CETCO
    SUPER PAC™ is a multi-purpose liquid polymer designed for minimizing fluid loss to the formation. Enhances properties of bentonite drilling fluids and creates optimum drilling efficiency through filtration control....
    See more like this

    Reinforcement Spacers

    Cordek
    Gripper and Tric-trac spacers are designed to support the steel reinforcement used within reinforced concrete structures. The spacers remain in-situ throughout the construction process allowing the reinforcement to become encased in concrete. When installed co...

    5 specifiers have shown an interest in this product the last month.

    See more like this

    Koster NB 1 Grey waterproofing Slurry

    Delta Membrane Systems
    Mineral waterproofing system for positive (external) and negative side (internal) waterproofing against pressurized water. This mineral coating contains crystallizing and capillary-plugging agents. It is resistant against chlorides, sulphates and phosphates. C...

    1 specifiers have shown an interest in this product the last month.

    See more like this

    EPS Cylindrical Voidfillers (Expanded Polystyrene)

    S and B EPS Ltd
    S and B fill, with its versatility, can be cut into many bespoke shapes including cylinders that are a major feature of voided concrete structures such as elevated motorways and bridges. It is widely used to produce sloping ramps in the construction of car ...

    10 specifiers have shown an interest in this product the last month.

    See more like this

    Sheet Pile Infills

    Cordek
    Cordek Sheet Pile Infills are designed as a quick, economical and lightweight solution to infilling the open pans in an exposed sheet pile wall. Manufactured to order from Filcor EPS (Expanded Polystyrene), they are available in a range of profiles and densiti...

    1 specifiers have shown an interest in this product the last month.

    See more like this

    Spillway Outfall

    CPM Group Ltd
    The CPM team has developed an off-site precast concrete solution Spillway system, so why spend days constructing an in-situ headwall on site when precast options are available now that are made under factory conditions and can be installed in hours, not days! ...

    5 specifiers have shown an interest in this product the last month.

    See more like this

    Permaban Signature

    Permaban Ltd
    Permaban Signature® is an armoured joint like no other. The clever half-hexagon shape - called ‘disruptive face’ technology - prevents the wheels of materials handling vehicles from dropping into the gap between the two edges of the joint. Because there...

    16 specifiers have shown an interest in this product the last month.

    See more like this

    Ground & Substructure Building Products

    Ground and Substructure products form an essential part of any building, regardless of its size, shape, or structure. The majority of groundwork and substructure works are undertaken in order to prepare the construction site for the structure and to create the foundations needed to support it.

    This category encompasses a broad range of products including everything from ground beams, piling, protection systems, raft foundations and retaining walls, through to tanking, underpinning, geotextiles, and groundwater control products.

    Whether you’re looking for basement waterproofing, damp proofing, gas and water outlets, Voldrain, steel driven piles, ground form, slurry walls, reinforcement spacers, Corgrid, waterproofing slurry, cavity barriers, or anything in between, SpecifiedBy will allow you to search and compare the most extensive range of Ground and Substructure products from the leading manufacturers in the UK marketplace, with minimum fuss.

    Our leading manufacturers include Max Frank, Tobermore, Permaban Ltd, Delta Membrane Systems, CETCO, Eurocell, and Cordek.